How to Untangle Your LED Flagpole Christmas Tree Lights
Strands in a knot or wrapped around the pole? Here is how to get your LED Flagpole Christmas Tree Lights straight again in about half an hour, and how to store them so it does not happen next year.
In this guide 5 sections

A tangle happens to almost everyone at some point. The strands come out of the box in a knot, a windy night twists them around the pole, or they went into storage in a hurry last January. The good news: a tangle in your LED Flagpole Christmas Tree Lights is almost never as bad as it looks. With a little room and some patience, most trees come apart in 20 to 30 minutes.
Before you start
- Unplug the lights. Never work on strands while they are plugged in.
- Take the lights off the pole if they are up. Lower the top ring (the hanger every strand hangs from) and bring the whole tree down to the ground. Untangling overhead only makes it worse.
- Pick a big, dry, flat spot. A driveway or a patch of lawn works best. You want room to lay every strand out straight.
- Grab a helper if you can. One person holds the top ring while the other walks the strands out.
- Have a few things handy: gloves, your ground stakes, and some soft ties or clothespins to hold strands that are already straight.
Step by step: untangling the strands
- Set the top ring down in the middle. Lay it flat on the ground in the center of your space. Every strand starts here, so this is your anchor.
- Find the bottom ends. Each strand ends in a loop or tab that goes over a ground stake. Find as many loose ends as you can and pull them gently out from the pile.
- Walk out one strand at a time. Take one bottom end and slowly walk it away from the top ring in a straight line, like a spoke on a wheel. Stake it down or clip it so it stays put, then go back for the next one.
- Loosen knots, do not pull them. When a strand stops, look for the loop that is catching. Open the loop up and pass the end back through it. Pulling hard tightens a knot and can strain the wire and the LEDs.
- Watch for twisted pairs. If two strands are wound around each other from top to bottom, the top ring has usually been turned. Rotate the ring slowly until the pair falls apart, instead of untwisting the strands by hand.
- Work around the circle. Keep spacing the strands evenly as you go. When you are done, the tree should look like a star on the ground: the ring in the middle and every strand running straight out to its stake.
- Do a quick test. Plug the tree in while it is still on the ground. If a strand is dark, check its connection at the top ring before you raise the tree.
If the tree is twisted on the pole
Sometimes the strands are fine but the whole tree has wrapped around the flagpole after a windy night. Before you take it down, try this: pull up the ground stakes on one side and walk them around the pole in the opposite direction of the twist, one or two at a time. Once the strands hang straight again, re-stake them evenly around the pole so they stay snug. If that does not free it, lower the tree and follow the steps above.

How to store it so it does not tangle next year
- Take it down the same way you put it up. Lay the tree out flat on the ground first, with every strand straight.
- Gather the strands in order. Starting at the top ring, bring the strands together side by side, like a bundle of straws, and tie them loosely every few feet with soft ties.
- Coil, do not stuff. Loop the bundle in big, loose coils, or wrap it around a piece of stiff cardboard or an old hose reel.
- Tape the stake ends together. Keeping the bottom ends in one bunch makes next year's setup much faster.
- Store it dry. Put the coiled tree back in its box or a bin with a lid, and keep it somewhere dry for the year.
Still stuck? We are here to help
If your tree still will not come apart, or something does not look right, reach out to our team. Call or text us at (518) 400-0765, Monday to Friday, 9 AM to 5 PM Eastern, or send us a note through our contact page. A photo of the tangle helps us help you faster.
Looking to add lights to your flagpole this season? See our LED Flagpole Christmas Tree Lights.
Three Phoenix kits. One pole.
Every kit ships the same Phoenix telescoping flagpole. Patriot and Presidential add the light, the flags and the hardware most people buy later anyway.
Premier KitThe Phoenix pole, American flag, gold ball topper, ground sleeve and SECURI-SHUR™ anti-theft lock.See the Premier
Patriot KitEverything in the Premier, plus the 800 Series TelePatriot™ solar light and an eagle flag.See the Patriot
Presidential KitAdds a 12" gold eagle topper, the solar light, three flags and a color-matched flash collar.See the Presidential






